Specifies how a LocoIO port is configured.
Namespace: RRAutoLib.LoconetAssembly: RRAutoLib (in RRAutoLib.dll) Version: 1.4.4714.25322
Syntax
Members
| Member name | Value | Description | |
|---|---|---|---|
| NotDefined | 0 | An empty and invalid configuration. All ports start out with this configuration after the LocoIO firmware is written. | |
| InInpRepActLow | 497 | Generates PkInput packets. Input is active low. | |
| InInpRepActHigh | 1520 | Generates PkInput packets. Input is active high. | |
| InSwReqToggle | 241 | Generates PkSetSwitch packets. Toggle switch input. | |
| InSwRepToggle | 113 | Generates PkSwitchInput packets. Toggle switch input. | |
| InSwReqPushBtnActLow | 753 | Generates PkSetSwitch packets. Push button input is active low. | |
| InSwReqPushBtnActHigh | 1776 | Generates PkSetSwitch packets. Push button input is active high. | |
| InSwRepPushBtnActLow | 625 | Generates PkSwitchInput packets. Push button input is active low. | |
| InSwRepPushBtnActHigh | 1648 | Generates PkSwitchInput packets. Push button input is active high. | |
| InSwRepFeedbackOne | 375 | Generates PkSwitchInput packets. Feedback with one sensor. | |
| InSwRepFeedbackTwo | 886 | Generates PkSwitchInput packets. Feedback with two sensors. | |
| OutInpRepNorm | 3072 | Acts on PkInput packets. | |
| OutInpRepBlink | 3328 | Acts on PkInput packets. Output will blink at the rate specified by BlinkingRate. | |
| OutSwReqOffNorm | 2049 | Acts on PkSetSwitch packets. Port is off at power up. | |
| OutSwReqOffBlink | 2305 | Acts on PkSetSwitch packets. Port is off at power up. Output will blink at the rate specified by BlinkingRate. | |
| OutSwReqOnNorm | 2065 | Acts on PkSetSwitch packets. Port is on at power up. | |
| OutSwReqOnBlink | 2321 | Acts on PkSetSwitch packets. Port is on at power up. Output will blink at the rate specified by BlinkingRate. | |
| OutSwReqPulseManual | 2176 | Acts on PkSetSwitch packets. Pulse with a manual reset. | |
| OutSwReqPulseAuto | 2240 | Acts on PkSetSwitch packets. Pulse with an auto reset if manual reset not received. |
Remarks
See Also